Mitsubishi Magna TR, TS Series 1991 - 1996 Workshop Manual

By: Gregory's .

Mitsubishi Magna TR, TS Series 1991 - 1996 Repair Manual covers:

Models: TR, TS Series GLX, Executive, SE, Elite
Sedan, Wagon
April 1991 - 1996
2.6 Litre Carb.
2.6 Litre EFI
4 Cylinder

This Gregory's Service and Repair Manual covers the Australian manufactured TR series Mitsubishi Magna. Introduced during April 1991, the TR Magna was initially available only in Executive, SE and Elite variant sedans. The GLX variant was not available until November 1991. Station Wagons were introduced in April 1992 in all variants except Elite.
The Magna is powered by a four cylinder, 2.6 litre overhead camshaft engine which has two chain driven counter balance shafts mounted in the cylinder block to reduce engine vibration.
The electronic multipoint fuel injection system is standard on all variants except GLX, which is equipped with a carburettor. Premium unleaded fuel can be used in models equipped with fuel injection to gain a slight increase in power and torque. The use of premium unleaded fuel in carburettor models will not increase maximum power and torque.
The engine is mounted transversely and drive to the front wheels is transmitted through a five speed manual or four speed, electronically controlled automatic trans-axle.
All models are equipped with MacPherson strut type independent front suspension. The rear suspension on Sedan models consists of a torsion axle supported by Mac-Pherson struts and located by two trailing arms that are integral with the axle and a panhard rod. On Station Wagon models, the rear suspension consists of a tubular axle located by two upper and lower control arms and a panhard rod. The axle is supported by coil springs and telescopic shock absorbers are installed between the body and the axle.
Power steering and four wheel, vacuum assisted disc brakes are standard on all models.
On SE and Elite models, the radio/cassette is equipped with a security system that renders it inoperable if the security code is erased due to the power supply being disconnected. The security code must be entered to permit the radio/cassette to function.
This manual includes information on trouble shooting, lubrication and maintenance, specifications and the removal, installation and overhaul of components which are considered to be within the scope of the average, well equipped home mechanic.
Certain repair jobs covered in this manual require the use of special equipment not normally found in a home tool kit. When such equipment is required, the equipment and its function is brought to the users attention underneath the heading for that component. Some jobs, such as automatic transmission overhaul, should be left to an authorised dealer or a specialist who has the extensive knowledge and equipment required. In these cases, the removal and installation procedures are fully covered, enabling the unit to be removed for repair or a reconditioned unit to be installed.

Other Details